Hello Tech E500 SC6531E Flash File and Boot Key Tested 

Boot Key Tested;  Call key

You can use the Universal Bootable cable instead of any key pressed

Caution, Before any operation,  First backup your mobile firmware.

How to use a Boot key

1-Remove the batter from the set.

2-Press and hold the recommended Boot key.

3-Insert the USB cable into the mobile base, the second end connected to the PC port already. 

4-At the same time put the battery again.

5-Your mobile will be detected and detect the correct bootloader if the boot key is correct.

Flashing Requirement :

   1- Download and install Spreedtrum USB Drivers Latest 

   2- Desire Box or Dongle / Tool setup are installed on your PC

   3- USB cable / Bootable cable/ SPD bootable Cable 

1-Install the required SPD Drivers

2-Install the infinity box module "SCR...

3-Select the require TAB

4-Select Modle CPU type 

5-Select Function as/ Reas Flash /Write Flash /Formate etc...

6-Press & Hold the Boot Key and connect the USB cable to Mobile

Log

Operation : Read Flash [ v1.06 ]

1. Power off device

2. Press and hold BootKey or use BootCable

3. Insert cable and battery in device!

Wait for device ... 

Device Connected!

BootVersion: SPRD3

BootSource  :  InternalLibrary

BootVersion : Infinity SCR SC6531E Loader v 1.2

Port speed : 921600

FDL Flash  : Control transfered!

Boot Done!

CS0_MEM : SPI : [WINBOND] : W25Q32 : 0x00400000 [ 4MiB ]

Read Flash Ok, Size : 4.00 MiB

E318_ITL_K13A1_HELLO_TECH_E500_128160_20211030

Project Version: SC6531EFM_BAR

MMI Version: SC6531EFM_BAR

BASE  Version: BASE_SVN

HW Version: SC6531EFM_BAR

10-30-2021 16:00:22

LOG Version:    V1.0.1

Saved to : C:\Users\Ijaz\Desktop\New folder\E318_ITL_K13A1_HELLO_TECH_E500_128160_20211030.bin

Done!

Elapsed: 00:01:19

CAUTION 

                     FIRST READ BEFORE YOU WRITE 

FLASH FILE

FILE  VERSION 

E318_ITL_K13A1_HELLO_TECH_E500_128160_20211030.bin

file Here